Seven operation steps of using peanut peeling machine
Peanut peeling machine is an ideal equipment for peeling peanuts, almonds and broad beans. Matched with the fried peanuts production line, it can be used in the production of large manufacturers. This machine can also be used to remove the skin of almonds and broad beans. Now after improvement, after replacing some parts, the skin of small almonds can be removed. Let's introduce the operation steps of peanut peeling machine:
1、 Before using the peanut peeling machine, first check whether the fasteners are tightened, whether the rotating part is flexible, whether there is lubricating oil in each bearing and whether the peeling machine is placed stably. In order to ensure the safety of operators, grounding protection shall be taken for the shell of the motor (the shell of the motor shall be reliably connected with the grounding body with wires).
2、 Before power on, manually turn the peanut peeling machine for several turns. If there is a collision sound, find out the cause and then power on.
3、 Appropriate screen should be selected according to the size of peanut kernel.
4、 After power on, test run first and pay attention to whether the rotation direction of the rotor is correct. After the motor is started, the rotation direction of the rotor shall be consistent with the direction marked on the machine. First idle for a few minutes and observe whether there is abnormal sound. After the operation is normal and stable, the peanuts can be put into the hopper quantitatively, evenly and continuously.
5、 There are also requirements for the degree of dryness and wetness of peanuts, that is, peanuts cannot be too dry or too wet. Too dry, high peanut crushing rate; If it is too wet, the shelling speed will slow down. In winter, peanuts stored in rural areas are generally dry. In order to make them dry and wet, the following methods can be adopted: spray about 15kg of warm water evenly on 100kg of peanuts, cover them with plastic film for about 10 hours, and then dry them in the sun for about 1 hour to start shelling. In other seasons, it only takes about 6 hours to cover with plastic film, and the other operation methods are the same.
6、 The way to solve the increase of peanut shells is to move the motor downward in order to tension the fan belt and increase the blowing amount.
7、 During peeling, the peanut fruit shall be fed evenly and appropriately. It is not allowed to mix iron filings, stones and other sundries to prevent breaking the peanut kernel or causing mechanical accidents. When the peanut kernel is covered with the sieve surface, the outlet switch can be turned on.
